Toyota 1 MZ–FE Manual page 575

EG2–575
1MZ–FE ENGINE – CIRCUIT INSPECTION
Fuel Pump Control Circuit
CIRCUIT DESCRIPTION
Fuel pump control
The fuel pump is switched on (low voltage at terminal FC) when STA is on or while the NE signal is input
to the ECM.
In the diagram below, when the engine is cranked, current flows from terminal ST of the ignition switch
to the starter relay coil, the starter relay switches on and current flows to coil L1 of the circuit opening relay.
Thus the circuit opening relay switches on, power is supplied to the fuel pump and the fuel pump operates.
When the STA signal and NE signal are input to the ECM, Tr is turned ON, current flows to coil L2 of the
circuit opening relay, the relay switches on and the fuel pump operates.
While the NE signal is generated (engine running), the ECM keeps Tr ON (circuit opening relay ON) and
the fuel pump also keeps operating.