EG2–278
1MZ–FE ENGINE
–
SFI SYSTEM
INTAKE AIR CONTROL VALVE
INSTALLATION
(See Components for Removal and Installation)
1. INSTALL INTAKE AIR CONTROL VALVE
(a) Install a new gasket to the air intake chamber.
(b) Apply a light coat of engine oil to the rubber portions.
(c) Apply seal packing to the positions of the intake air
control valve shown in the
Seal packing:
Part No.08826–00080 or equivalent illustration.
(d) Install the intake air control valve, DLC 1 bracket and 2
ground straps with the 4 nuts.
Torque: 14.5 N–m (145 kgf–cm, 10 ft–lbf)
2. CONNECT HOSES TO INTAKE AIR CONTROL
VALVE
(a) Connect the following hoses:
(1) Brake booster vacuum hose
(2) A/C idle–up air hose
(3) Actuator vacuum hose
(b) Install the DLC1.
3. CONNECT NEGATIVE (–) TERMINAL CABLE
TO BATTERY
4. CHECK FOR FUEL LEAKAGE
(See page EG2–228)