Toyota 1 MZ–FE Manual page 111

1MZ–FE ENGINE – ENGINE MECHANICAL
25. INSTALL NO.2 IDLER PULLEY
(a) Install the idler pulley with the bolt.
Torque: 43 N–m (440 kgf–cm, 32 ft–lbf)
(b) Check that the idler pulley moves smoothly.
26. INSTALL RH CAMSHAFT TIMING PULLEY
(a) Install the timing pulley, facing the flange side out–
ward.
(b) Align the knock pin hole of the camshaft with the
knock pin groove of the timing pulley as shown.
(c) Using SST, install and torque the bolt.
SST 09249–63010, 09960–10010 (09962–01000)
Torque: 88 N–m (900 kgf–cm, 65 ft–lbf)
HINT: Use a torque wrench with a fulcrum length of
340 mm (13.39 in.)
27. INSTALL LH CAMSHAFT TIMING PULLEY
(a) Install the timing pulley, facing the flange side inward.
(b) Align the knock pin hole of the camshaft with the
knock pin groove of the timing pulley as shown.
(d) Using SST, install and torque the bolt.
SST 09960–10010 (09962–01000)
Torque: 125 N–m (1,300 kgf–cm, 94 ft–lbf)
EG2–111