Toyota 1 MZ–FE Manual page 326

EG2–326
1MZ–FE ENGINE – FE ENGINE – COOLING SYSTEM
3. CONNECT ENGINE WIRE
Connect the engine wire with the 3 clamps.
4. INSTALL N0.2 IDLER PULLEY
(a) Install the idler pulley with the bolt.
Torque: 43 N–m (440 kgf–cm, 32 ft–lbf)
(b) Check that the idler pulley moves smoothly.
5. INSTALL RH CAMSHAFT TIMING PULLEY
(a) Install the timing pulley, facing the flange side out–
ward.
(b) Align the knock pin hole of the camshaft with the
knock pin groove of the timing pulley as shown.
(c) Using SST, install and torque the bolt.
SST 09249–63010, 09960–10010 (09962–01000)
Torque: 88 N–m (900 kgf–cm, 65 ft–lbf)
HINT: Use a torque wrench with a fulcrum length of
340 mm (13.39 in.)