Toyota 1 MZ–FE Manual page 161

1MZ–FE ENGINE – ENGINE MECHANICAL
2. REPLACE CRANKSHAFT REAR OIL SEAL
A. If rear oil seal retainer is removed from cylinder
block:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal until its
surface is flush with the rear oil seal retainer edge.
SST 09223 –15030, 09608 – 30022 (09608 – 05010)
(c) Apply MP grease to the oil seal lip.
B. If rear oil seal retainer is installed to cylinder block:
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape
the screwdriver tip.
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer, tap in the oil sea! until its
surface is flush with the rear oil seal retainer edge.
SST 09223–15030, 09608–30022 (09608–05010)
EG2–161