Toyota 1 MZ–FE Manual page 53

1MZ–FE ENGINE – FE ENGINE – ENGINE MECHANICAL
(b) Check that the timing marks of the RH and LH timing
pulleys with the timing marks of the No.3 timing belt
cover as shown in the illustration.
If the marks do not align, remove the timing belt and
reinstall it.
(c) Remove the crankshaft pulley bolt.
11. INSTALL TIMING BELT GUIDE
Install the belt guide, facing the cup side outward.
12. INSTALL ENGINE RH MOUNTING BRACKET
Install the mounting bracket with the 2 bolts and nut.
Torque: 28 N–m (290 kgf–cm, 21 ft–lbf)
13. INSTALL N0.2 TIMING BELT COVER
(a) Check that the timing belt cover gasket has no cracks
or peeling, etc.
If the gasket does have cracks or peeling, etc., replace
it using following steps.
(1) Using a screwdriver and gasket scraper, remove
all the old gasket material.
(2) Thoroughly clean all components to remove all
the loose material.
(3) Remove the backing paper from a new gasket
and install the gasket evenly to the part of the
belt cover shaded black in the illustration.
(4) After installing the gasket, press down on it sc
that the adhesive firmly sticks to the belt cover.
(b) Install new gasket to the No.2 belt cover.
EG2–53