Toyota 1 MZ–FE Manual page 44

EG2–44
1MZ–FE ENGINE – ENGINE MECHANICAL
15. REMOVE ENGINE RH MOUNTING BRACKET
Remove the 2 bolts, nut and mounting bracket.
16. REMOVE TIMING BELT GUIDE
17. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Temporarily install the crankshaft pulley bolt to the
crankshaft.
(b) Turn the crankshaft and align the crankshaft timing
pulley groove with the oil pump alignment mark.
NOTICE: Always turn the crankshaft clockwise.
(c) Check that timing marks of the camshaft timing pul–
leys and No.3 timing belt cover are aligned.
If not, turn the crankshaft 1 revolution (360°).
(d) Remove the crankshaft pulley bolt.