EG2–294
1MZ–FE ENGINE
–
SFI SYSTEM
C. Inspect VSV operation
(a) Check that air flows from pipe E to the filter.
(b) Apply battery voltage across the terminals.
(c) Check that air flows from pipe E to pipe F.
If operation is not as specified, replace the VSV.
6. REINSTALL EMISSION CONTROL VALVE SET
(See step 8 on page EG2–256)
7. REINSTALL VSV
(a) Install the VSV with the screw.
(b) Connect the 2 vacuum to the VSV.
8. REINSTALL V–BANK COVER
Using a 5 mm hexagon wrench, install the V – bank
cover with the 2 cap nuts.
HINT: For fixing the V–bank cover, push on the cover
until sense of "click" is felt.
9. RECONNECT NEGATIVE (–) TERMINAL CABLE
TO BATTERY