Toyota 1 MZ–FE Manual page 358

EG2–358
1MZ–FE ENGINE – COOLING SYSTEM
7. INSPECT DRIVE SHAFT PRELOAD
(a) Check that the drive shaft rotates smoothly without
abnormal noise.
(b) Temporarily install the pulley nut, and check the rotat–
ing torque.
Rotating torque:
0.3 N–m (3.0 kgf–cm, 2.6 in.–lbf)
HYDRAULIC MOTOR INSTALLATION
(See Components for Removal and Installation)
1. INSTALL HYDRAULIC MOTOR TO FAN SHROUD
Install the hydraulic motor with the 3 bolts.
Torque: 4.9 N–m (50 kgf–cm. 43 in.–lbf)
2. INSTALL COOLING FAN TO HYDRAULIC MOTOR
Install the fan with the plate washer and nut. Tighten
the nut by turning it counterclockwise.
Torque: 15 N–m (150 kgf–cm, 11 ft–lbf)
3. INSTALL HYDRAULIC COOLING FAN
Install the hydraulic cooling fan with the6 bolts.
Torque: 4.9 N–m (50 kgf–cm, 43 In.–Ibf)
4. INSTALL RADIATOR
(See page EG2–342)