Toyota 1 MZ–FE Manual page 160

EG2–160
1MZ–FE ENGINE – ENGINE MECHANICAL
CRANKSHAFT OIL SEALS REPLACEMENT
HINT: There are 2 methods (A and B) to replace the oil
seal which are as follows:
1. REPLACE CRANKSHAFT FRONT OIL SEAL
A. If oil pump is removed from cylinder block:
(a) Using a screwdriver, pry out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal until its
surface is flush with the oil pump body edge.
SST 09223 – 00010
(c) Apply MP grease to the oil seal lip.
B. If oil pump is installed to the cylinder block:
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape
the screwdriver tip.
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump body edge.
SST 09223 – 00010