Toyota 1 MZ–FE Manual page 301

1MZ–FE ENGINE – SFI SYSTEM
(f) Remove the 2 gaskets.
5. REMOVE KNOCK SENSORS
(a) Disconnect the knock sensor connector.
(b) Remove the knock sensor.
6. INSPECT KNOCK SENSORS
Using an ohmmeter, check that there is no continuity
between the terminal and body.
If there is continuity, replace the sensor.
7. REINSTALL KNOCK SENSORS
(a) Install the knock sensor.
Torque: 39 N–m (400 kgf–cm. 29 ft–lbf)
(b) Connect the knock sensor connector.
8. REINSTALL WATER OUTLET AND RH ENGINE
MOUNTING STAY
(a) Install 2 new gaskets on the cylinder head.
(b) Install the water outlet with the the 2 bolts, 2 plate
washers and 2 nuts.
Torque: 15 N–m (150 kgf–cm, 11 ft–lbf)
NOTICE: Do not scratch the seal surface of the water
outlet with the stud bolt.
(c) Connect the water bypass hose to the inlet housing.
(d) Install the wire band.
(e) Install the RH mounting stay with the 3 bolts.
Torque: 31.4 N–m (320 kgf–cm, 23 ft–lbf)
EG2–301