Preliminary Switch Configuration; Web Ui Requirements; Launching The Ws5100 Series Switch Web Ui - Motorola WS5100 Series Installation Manual

4.3 Preliminary Switch Configuration

To complete a preliminary configuration of the WS5100, several different screens within
the Web UI will be referenced. The goal of the initial configuration, is to define settings
for the switch to associate to an MU with a minimal level of data protection. For advanced
switch configuration, refer to the WS5100 Series System Reference Guide, available on
the Motorola Web site.
Using the instructions below, define a WLAN policy and a security policy. Then, apply
these policies to the switch. After you have created and applied the policies, you should
be able to associate and communicate with a properly configured mobile unit. When ready
to verify the preliminary configuration described in this section, refer to
Configuration" on page

4.3.1 Web UI Requirements

The WS5100 Series Web UI is accessed using Internet Explorer version 5.5 and SUN JRE
(Java Runtime Environment) 1.5. (Later versions of IE and the SUN JRE are also supported.)
Refer to the Sun Microsystems Web site for information on downloading JRE.
To prepare Internet Explorer to run the WS5100 Series Web UI:
1. Open IE's Tools > Internet Options panel and select the Advanced tab.
2. Uncheck the following checkboxes:
• Use HTTP 1.1
• Java console enabled (requires restart)
• Java logging enabled
• JIT compiler for virtual enabled (requires restart)

4.3.2 Launching the WS5100 Series Switch Web UI

To display the WS5100 Series Switch Web UI, launch a Web browser on a computer with
the capability of accessing the WS5100.
4-11.
NOTE: HTTP access is required to use the WS5100 Web UI.
Configuration 4-3
"Verifying the