Machine Adjustment; Printer Area; Centering (Duplex 2Nd Side) - Konica Minolta bizhub C200 Service Manual

Field Service Ver. 2.0 Dec. 2008
5.

Machine Adjustment

5.1

Printer Area

5.1.1

Centering (Duplex 2nd Side)

NOTE
Make this adjustment after any of the following procedures has been performed.
The image on the backside of the 2-sided copy deviates in the main scan direction.
1. Call the Service Mode to the screen.
See P.158 of the main body service manual.
2. Touch [Machine Adjustment] → [Printer Area] → [Centering (Duplex 2nd Side)].
8. Produce another test print and check to see if width A falls within the specified range.
9. Perform the same check and adjustment procedures for the subsequent drawers.
10. Touch [OK].
11. Touch [OK] on the Service Mode screen.
12. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
A0ENF3E504DA
A
4061F3C809DA
5. Machine Adjustment
3. Touch [Tray 1].
4. Press the Start key to let the
machine produce a test print.
5. Touch [OK].
6. Measure the width of printed refer-
ence line A.
Specification: 3.0 mm
7. If the measured width A falls outside
the specified range, enter the correc-
tion value using the [
key.
±
2.0 mm
] or [ ]
13