Network Settings - Konica Minolta bizhub C200 Service Manual

Hide thumbs Also See for bizhub C200:

Table of Contents

8. Utility Mode

Network Settings

A. Basic Settings

• When the settings are changed, turn off the main power switch and turn it on again

more than 10 seconds after.

• To set whether to automatically acquire IP address or not by DHCP function.

• The default setting is Auto Input.

(2) IP Address

• This setting is available only when the following setting is in "IP Input" :

[Admin.] → [Network Settings] → [Basic Settings] → [DHCP].

• To set the IP address of this machine.

• Used to enter IP address when IP address is not automatically acquired by DHCP.

1. Touch [Network Settings] → [Basic Settings] → [IP Address].

2. Enter the IP address using the 10-key pad.

(3) Subnet Mask

• This setting is available only when the following setting is in "IP Input" :

[Admin.] → [Network Settings] → [Basic Settings] → [DHCP].

• To set the subnet mask of this machine.

1. Touch [Network Settings] → [Basic Settings] → [Subnet Mask].

2. Enter the subnet mask using the 10-key pad.

• This setting is available only when the following setting is in "IP Input" :

[Admin.] → [Network Settings] → [Basic Settings] → [DHCP].

• To set the gateway address.

1. Touch [Network Settings] → [Basic Settings] → [Gateway].

2. Enter the gateway address using the 10-key pad.

(5) Network Board Set

• To set the network board and to display the current operating status.

• To change the network board setting to suit the network environment.

• The default setting is Auto.

"Auto Input"

Field Service Ver. 2.0 Dec. 2008

Table of Contents