Konica Minolta bizhub C200 Service Manual page 756

Field Service Ver. 2.0 Dec. 2008
12. Perform another test print and check the reference deviation.
13. Repeat the adjustment until the reference line falls within the specified range.
14. Tighten the adjustment screw.
15. Touch [OK].
16. Touch [OK] on the Service Mode screen.
17. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
[1]
[2]
A093F3C506DA
[1]
[2]
A093F3C507DA
4348fs3512c0
4348fs3513c0
5. Mechanical adjustment
9. Press the drawer release button [1]
and then slide out the drawer [2]
from the paper feed cabinet.
10. Open the right door.
11. Loosen the adjustment screw [1] and
turn screw [2] to make the adjust-
ment.
NOTE
• Do not damage the passage surface
of the right door.
• If width A is greater than the specified
value:
Turn screw counterclockwise.
• If width A is smaller than the specified
value:
Turn screw clockwise.
25