Konica Minolta bizhub C200 Service Manual page 233

10. Service Mode
(2) Date & Time Setting
Functions • To set the data and time-of-day.
Use • Use to set or change the date and time-of-day.
Setting/ 1. Call the Service Mode to the screen.
Procedure 2. Touch [CS Remote Care].
3. Touch [Detail Setting] to access Date & Time Setting.
4. Enter the date (month, day and year), time-of-day, and the time zone from the 10-key
5. Touch [SET] to start the clock.
(3) RAM Clear
Functions • To clear the following data at the center
Use • To be used for setting CS Remote Care.
• To be used for reset the every data of the center to default.
NOTE
• If RAM clear is selected during transmission, RAM clear processing will be
Setting/ • The default setting is "Unset."
Procedure
(4) Communication Log Print
Functions • To print out the communication log.
Use • Use to output and use the communication log.
Setting/ 1. Call the Service Mode on the screen.
Procedure 2. Touch [CS Remote Care].
3. Touch [Detail Setting] to access communication log print.
4. Load tray 1 or bypass tray with A4S or 8
5. Press Start key to print out the communication log.
(5) Software Switch Setting
Functions • To change the CS Remote Care settings.
Use • To change the settings for CS Remote Care as necessary.
Setting/ • Refer to "Software SW setting for CS Remote Care" for the setting.
Procedure See P.184
(6) Response Time Out
Functions • It sets the intervals for resending e-mails when transmission error occurred.
• It can be set only when [E-Mail] is selected by System Setting.
Use • To use when changing the intervals for resending e-mails when transmission error
Setting/ • The default setting is 60 minute.
Procedure
192
1
pad.
ID Code, Primary Setting, Date/Time Input (Time Zone), Software SW Setting and AT
Command.
implemented at the time the transmission is completed regardless of whether
it is done properly or not.
Set
occurred.
Field Service Ver. 2.0 Dec. 2008
"Unset"
1 / x 11 paper.
2
"60 minute" (10 to 1440)