Konica Minolta bizhub C200 Service Manual page 647

5. Service Mode
4. Select the appropriate function according to what needs to be checked and adjusted.
• <1st side>
Original placement: Printed side up, arrow pointing to the leading edge
Simplex/Duplex: [1 > 1]
• <2nd side>
Original placement: Printed side down, arrow pointing to the trailing edge
Simplex/Duplex: [2 > 2]
• <3rd side>
Original placement: Printed side up, arrow pointing to the leading edge
Simplex/Duplex: [2 > 2]
Mixed Original: [ON]
* Copy paper A4S or letterS, auto zoom, mixed original
7. Touch [OK].
8. Touch [ADF Adjustment] → [Feed].
10. Touch [OK].
11. Press the Reset key.
12. Repeat steps 3 to 11 until the difference in the width falls within the specified range.
13. Touch [OK] on the Service Mode screen.
14. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
36
5. Measure width A and width B on the
A
6. If the difference in the width of a falls
B
A0EYF3C503DA
9. Touch the function to be adjusted
• If the width A on the copy is longer
than that on the chart, enter a positive
value using + key.
• If the width B on the copy is longer
than that on the chart, enter a positive
value using + key.
A0EYF3E511DA
Field Service Ver. 1.0 Jun. 2008
test chart and the copy to determine
if the difference in the width falls
within the specified range.
outside the specified range, make
the following adjustment.
and touch either [+] or [-] whichever
is applicable. Then, enter the
numeric data from the 10-key pad.