Machine Adjustment; Printer Area; Leading Edge Adjustment - Konica Minolta bizhub C200 Service Manual

Field Service Ver. 1.0 Jun. 2008
5.

Machine Adjustment

5.1

Printer Area

5.1.1

Leading Edge Adjustment

NOTE
• Make this adjustment after any of the following procedures has been performed.
When the PH unit has been replaced.
When the image on the print is offset in the sub scan direction.
A faint image occurs on the leading edge of the image.
1. Call the Service Mode to the screen.
See P.158 of the main body service manual.
2. Touch [Machine Adjustment] → [Printer Area] → [Leading Edge Adjustment].
8. Produce another test print and check to see if width A falls within the specified range.
9. Following the same procedure, adjust for transparency, thick 1 to 3, and envelope.
10. Touch [OK].
11. Touch [OK] on the Service Mode screen.
12. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
3. Touch [Plain].
4. Press the Start key to let the
5. Touch [OK].
A0EPF3E513DA
6. Measure the width of printed refer-
A
7. If the measured width A falls outside
A0EPF3C502DA
5. Machine Adjustment
machine produce a test print.
ence line A.
±
Specification: 4.2 mm
the specified range, enter the correc-
tion value using the [
key.
0.5 mm
] or [ ]
13