D Fixed Mode - Icom IC-7600 Instruction Manual

D Fixed mode

Displays signals within a specified frequency range.
The selected frequency band activity can be observed
at a glance when using this mode.
q Push [EXIT/SET] several times to close any multi-
function screens, if necessary.
Push [SCOPE](F-1) to select the scope screen.
w
[CENT/FIX](F-5) to select the fixed mode.
Push
e
• " " is displayed when the fixed mode is
selected.
• Push [CENT/FIX](F-5) to toggle between the center
and fixed modes.
• When the operating frequency moves past the upper or
lower edge frequency, "<<" or ">>" appears at the upper
side corners of the screen.
<<: The frequency is too low.
>>: The frequency is too high.
When the frequency goes further away, "Scope Out of
Range" is displayed.
To exit the spectrum scope screen, push
r
The scope bandwidth can be specified for each
frequency band independently in the scope set
mode. (pp. 76 to 78)
The Marker display in the fixed mode
In the fixed mode, the marker displays the operating
frequency. So, the transceiver always displays the
main marker.
• Marker types
: The main marker indicates the operating
frequency of the main band.
: The sub marker indicates the operating
frequency of the sub band.
: The TX marker indicates the transmit
frequency.
[MARKER](F-3) to select the desired marker.
Push
➥
• MAIN/SUB, MAIN/TX, MAIN/SUB/TX, or
only MAIN
• When the marker is displayed and the frequency is
out of range, "<<" or ">>" appears at the upper side
corners of the spectrum scope screen.
<<: The operating frequency is too low.
>>: The operating frequency is too high.
• Fixed mode screen
[EXIT/SET].
• The SUB maker is out of range (">>" appears)
RECEIVE AND TRANSMIT
F-1 F-5 EXIT/SET
SCOPE CENT/FIX
F-3
MARKER
4
4
72