Fujitsu Primergy BX900 System Message Manual page 388
Blade server systems
ethernet connection blade module sb6 / sb11a / sb11 switch and ibp version
Hide thumbs
Also See for Primergy BX900:
- User manual (811 pages) ,
- Hardware reference manual (69 pages) ,
- Configuration manual (67 pages)
Table of Contents
Advertisement
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error: Failed to delete Port Channel. This port channel is
configured as link state upstream.
The port-channel configured as upstream of a link state group
can not be deleted.
Remove the port-channel from link state group first.
Error: Failed to set Port Channel. Interface:
<interface_identifier> is configured as link state down stream.
The interface attached to link state downstream can not be set to
be the member of a port channel.
Remove the interface from link state group before adding it to a
port-channel or attach other interface to the port-channel.
Error: Failed to set Port Channel. Interface:
<interface_identifier> is configured as link state up stream.
The interface attached to link state upstream can not be set to be
the member of a port channel.
Remove the interface from link state group before adding it to a
port-channel or attach other interface to the port-channel.
Error: Failed to set Port Channel. Interface:
<interface_identifier> is configured as port backup.
The interface attached to port backup group can not be set to be
the member of a port-channel.
Remove the interface from port backup group before adding it to
a port-channel or attach other interface to the port-channel.
Error: Failed to set Member Ports. LACP Mode must be enabled
on member ports before they can be added to a Port Channel.
The interface can not be added to a port-channel if the LACP
Mode is disabled on this interface.
Enable the interface LACP Mode before adding it to a
port-channel.
Error: Failed to create Port Channel Members : Full-duplex is
needed.
The interface can not be added to a port-channel if half-duplex
Mode is set or operated on this interface.
Set the interface to operate at Full-duplex Mode before adding it
to a port-channel.
2011 Fujitsu Technology Solutions
©
Advertisement
Table of Contents
