Fujitsu Primergy BX900 System Message Manual page 180

Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
DHCP6 Client Restarted.
User input 'oob protocol dhcp6 restart' command.
Use 'oob protocol dhcp6 restart'.
Are you sure you want to restart the DHCP6 client service? (y/n)
User input 'oob protocol dhcp6 restart' command.
Use 'oob protocol dhcp6 restart'.
Changing protocol mode will reset dhcp6 configuration.
User input 'oob protocol none dhcp6' command.
Use 'oob protocol none dhcp6'.
Error! 'ipv6 dhcp6 restart'.
Duplicate user input 'ipv6 dhcp restart'.
Use 'ipv6 dhcp6 restart'.
Changing protocol mode will reset ipv6 configuration.
Are you sure you want to continue? (y/n)
Changing protocol mode with reset ipv6 IP address for interface
VLAN mode.
Use ' ipv6 address protocol dhcp6'
Incorrect input! Use 'ipv6 address protocol {dhcp6 | none}'.
User input incomplete command.
Use ' ipv6 address protocol {dhcp6 | none}'.
Protocol mode not changed!
User input changing protocol mode command then enter 'n' (not
change mode).
Use ' ipv6 address protocol {dhcp6 | none}'.
Only one interface can run DHCP6.
Configure switch port protocol to none.
When user already use oob mgmt interface to configure
DHCPv6, then into interface VLAN mode to changing protocol
mode with ipv6 configuration will cause this error message.
Configure oob mgmt interface protocol to none. Use 'ipv6
address protocol {dhcp6 | none}'.
2011 Fujitsu Technology Solutions
©