Fujitsu Primergy BX900 System Message Manual page 135

This section contains the Configuration Out-Band Mgmt messages.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Incorrect input! Use 'oob ip <ipaddr> <netmask>'.
Incomplete command for this function.
Use 'oob ip <ipaddr> <netmask>'.
Incorrect input! 'netmask must have contiguous ones'.
User input incorrect form of netmask.
Configure the netmask in the form of <a.b.c.d> .
Incorrect input! Use 'oob protocol {none [dhcp6] | bootp | dhcp |
dhcp6}'.
Incomplete command for this function.
Use 'oob protocol {none [dhcp6] | bootp | dhcp | dhcp6}'.
Incorrect input! Use 'oob gateway <gateway>'.
Incomplete command for this function.
Use 'oob gateway <gateway>'.
Could not configure gateway.
Only one gateway could be set in a switch.
Please check if the gateway has been set by DHCP/Bootp.
IP address and gateway do not reside on the same subnet!
User input invalid IP address for oob gateway.
OOB IP address and OOB gateway should be on the same
subnet.
oob mgmt interface protocol must be none to set IP address.
User can't configure a fixed IP address while Out-of-band
management interface is set to get the IP address via
DHCP/Bootp protocol.
Change the protocol to none before configuring IP address.
Only one interface can run DHCP or Bootp. Configure network
protocol to none.
User attempt to set oob protocol to DHCP or Bootp, but the IP
interface has already set to DHCP or Bootp.
Change the protocol to none or change ip interface protocol to
none.
2011 Fujitsu Technology Solutions
©