4.3.6
Port
This section contains the port module messages.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error: Failed to set Capability.
User try to change the speed Capability of the interface, but the
interface doesn't exist in the system.
Refresh the WEB page, and select the interface again.
Error: Failed to set Physical Mode.
User try to change the Physical mode of the interface, but the
interface doesn't exist in the system.
Refresh the WEB page, and select the interface again
Error: Failed to set LACP Mode <interface identifier>.
User try to change the LACP mode of the interface, but the
interface doesn't exist in the system.
Refresh the WEB page, and select the interface again.
Error: Failed to set Link Trap.
User try to change the Link Trap of the interface, but the interface
doesn't exist in the system.
Refresh the WEB page, and select the interface again.
Error: Failed to set Admin Mode.
User try to change the Admin Mode of the interface, but the
interface doesn't exist in the system.
Refresh the WEB page, and select the interface again.
Error: Failed to set Admin Mode. Interface <interface identifier>
was disabled by e-keying function.
User try to enable a interface, but it is failed. The interface is
disabled by the e-Keying function.
Check the e-Keying status of this interface first. User does not
allow to enable it while the e-Keying status is disabled.
To enable the e-Keying, please refer to the MMB operations.
2011 Fujitsu Technology Solutions
©