Fujitsu Primergy BX900 System Message Manual page 361

Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error: Invalid Snooping Querier VLAN Address.
The invalid IPv6 address can not set for MLD Snooping Querier
VLAN address.
Set MLD Snooping Querier VLAN address with valid IPv6
address in form fe80:x:x:x:x:x:x:x and fe80::x .
Snooping Querier VLAN Address requires a IPv6 address in
form fe80:x:x:x:x:x:x:x and fe80::x.
The IPv6 address of MLD Snooping Querier is out of range.
Set MLD Snooping Querier Address with valid IPv6 address in
form fe80:x:x:x:x:x:x:x and fe80::x .
Error: There are no ports assignment.
There are no ports assigned to MLD Multicast Static Group.
Assign ports to MLD Multicast Static Group.
Error: MLD ADMIN must be enable.
MLD ADMIN is not enabled.
MLD ADMIN must be enabled before configuring the setting.
Error: MAC Address requires a MAC address in form
33:33:xx:xx:xx:xx.
Only Multicast MAC addresses can be set for MLD Multicast
Static Group.
Create MLD Multicast Static Group with non-reserved Multicast
MAC address.
Error: You cannot define L2Mcast Group for these MAC
addresses from 33:33:00:00:00:00 to 33:33:00:00:00:FF
The reserved Multicast MAC addresses can not be set for MLD
Multicast Static Group.
Create MLD Multicast Static Group with non-reserved Multicast
MAC address.
Error: Failed to create MAC Filter.
ERROR: Filter already exists.
User try to add a MLD Multicast Static Group, but the MLD
Multicast Static Group has already existed.
Check the MLD Multicast Static Group setting or use another
multicast MAC address to create the new MLD Static Group.
2011 Fujitsu Technology Solutions
©