Fujitsu Primergy BX900 System Message Manual page 244
Blade server systems
ethernet connection blade module sb6 / sb11a / sb11 switch and ibp version
Hide thumbs
Also See for Primergy BX900:
- User manual (811 pages) ,
- Hardware reference manual (69 pages) ,
- Configuration manual (67 pages)
Table of Contents
Advertisement
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
ERROR: syntax error, command: no switchport multicast all
User input incomplete command .
Use command 'no switchport multicast all'
Incorrect input! Use 'port-monitor session <session-id> {mode |
source interface <slot/port> [tx | rx] | destination interface <slo
t/port> }'.
User input incomplete command.
Use 'port-monitor session <session-id> {mode | source interface
<slot/port> [tx | rx] | destination interface <slo
t/port> }'.
Incorrect input! Use 'no monitor [session <session-id> [{mode |
source interface <slot/port> | destination interface}]]'.
User input incomplete command.
Use 'no monitor [session <session-id> [{mode | source interface
<slot/port> | destination interface}]]'.
This interface can not be configured as destination port.
User attempt to set the port-channel interface to be destination
port.
User can only set the normal ports to be destination port.
Probe port must be reset before re-configuring it.
User attempt to change the destination port.
User must delete the original destination port and then set a new
one.
Interface is not configured.
User attempt to delete the destination port but it was not created.
Make sure the destination had been created.
2011 Fujitsu Technology Solutions
©
Advertisement
Table of Contents
