Port-Channel - Fujitsu Primergy BX900 System Message Manual

4.3.7

Port-Channel

This section contains the Port-Channel module messages.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error: Failed to set <portChannelName>. Port Channel Name
must contain alphaNumeric characters only.
The Port Channel Name is not alphanumeric character.
Set Port Channel Name with up to 15 alphanumeric character.
Error: Failed to create lag. Valid name not specified.
The Port Channel Name is blank.
Assign the Port Channel Name with up to 15 alphanumeric
character before creating the port-channel interface.
Error: This port-channel name already exists.
The port-channel name is already used.
Set other port-channel name which is not configuerd.
Error: Failed to set Port Channel.
There are 64 maximum Port Channels already created.
Reduce other unnecessary Port Channel. Maximum supported
port-channel is 64.
Error: This port channel is an up stream port of link state group.
Internal ports can't be its member.
The port-channel is set to be the upstream port of a link state
group. So, the internal port can not be the member of a uplink
port-channel.
Add internal port to be the member of the downlink port-channel.
Error: This port channel is a downstream port of link state group.
External ports can't be its member.
The port-channel is set to be the downstream of a link state
group. So, the external port can not be the member of a
downstream port-channel.
Add external port to be the member of the uplink port-channel.
<interface_identifier> is already a member of another LAG.
The interface is already attached to another port-channel.
Remove the interface from other port-channel and then add it to
the new port channel.
2011 Fujitsu Technology Solutions
©