Fujitsu Primergy BX900 System Message Manual page 113

Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
5
Management unit conflict was detected and this unit has lost the
manager election. All the units in this stack will reset and join the
winner Stack Manager %x:%x:%x:%x:%x:%x.
Two stack masters in a stack, the current stack master loses the
master role and all the units belonging to this stack will be reset
and join the winner stack master later.
Please refer to the power consideration sequences of a stack to
prevent two stack masters in the same stack at the same time.
0
Auto upgrade reset unit <unit-id>
The FW of this unit is auto-upgrade complete by the stack
master and stack master reset this unit.
A notification message for user that this unit is reset by the stack
master due to the auto image upgrade complete.
5
No Potential unit to configure as Standby when unit <unit-id>
joined
No other unit to be configured as the standby unit. This unit
should be the only one stack member in the stack.
No standby unit is used in current stack.
5
No Potential unit to configure as Standby when unit <unit-id> left
No other unit to be configured as the standby unit. This unit
should be the only one stack member in the stack.
No standby unit is used in current stack.
5
Admin configured standby %d left the stack
The configured standby unit is left the stack.
Checking if this unit has been removed from the stack.
3
This unit <unit-id> does not have admin management preference
enabled
This unit has been configured to be a non-management unit. It
can't be selected as a standby unit.
To enable the admin management preference if you want this
unit to be a standby unit.
2011 Fujitsu Technology Solutions
©