Port-Group - Fujitsu Primergy BX900 System Message Manual

3.3.2

Port-Group

This section contains the Port-Group module messages.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Incorrect input! Use 'port-group <portGroupName>
[<uplinkSetName>]'.
Incomplete command for this function.
Use complete command 'port-group <portGroupName>
[<uplinkSetName>]'.
Incorrect input! Use 'no port-group <portGroupName>'.
Incomplete command for this function.
Use complete command 'no port-group <portGroupName>'.
Incorrect input! Port Group name can not more than 32
characters.
User input a Port Group name, the length of name exceeded 32
characters.
The length of the Port Group name should less than 32
characters.
Incorrect input! Port Group name must contain alphanumeric
characters only.
User input non alphanumeric characters for Port Group name.
Use alphanumeric characters for the Port Group name.
Incorrect input! Port Group <portGroupName> has been used!!
User try to create a new Port Group that has already exist in the
system.
Use the correct Port Group name for this function.
Incorrect input! Port Group <portGroupName> does not exist!!
User input a Port Group name, but the Port Group doesn't exist.
Use the correct Port Group name for this function.
ERROR: Port Group table is full.
User try to create a new Port Group, but the Port Group table
has reached the maximum.
The maximum Port Group is 36, please check the Port Group
setting.
2011 Fujitsu Technology Solutions
©