3.3.11
Port-backup
This section contains the Port-backup module messages.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Incorrect input! Use 'port-backup <uplinkSetName>
[failback-time <value>]'.
Incomplete command for this function.
Use complete command 'port-backup <uplinkSetName>
[failback-time <value>]'.
Incorrect input! Use 'no port-backup <uplinkSetName>
[failback-time]'.
Incomplete command for this function.
Use complete command 'no port-backup <uplinkSetName>
[failback-time]'.
Incorrect input! Use 'show port-backup [<uplinkSetName>
[status] | status ] '.
Incomplete command for this function.
Use complete command 'show port-backup [<uplinkSetName>
[status] | status ] '.
ERROR: Could not set internal port '%s' on Port Backup port.
User try to add an internal port to the backup port.
Internal port doesn't support the Port Backup function.
Error: It is not allowed to configure the last member of active port
to backup port !!
User try to change the last active port to backup port.
The Uplink set should have at least one active port; user can't
change all member ports to the backup ports.
Set Uplink Set '%s' backup failure!!
User try to add an interface to backup port, but the interface is
not belong to any Uplink set. Or the interface is a logical
interface not a physical interface.
Use a physical interface that has added to Uplink set for this
function.
2011 Fujitsu Technology Solutions
©