Installing A Parallel Port; How To Install A Parallel Port - Fujitsu PRIMERGY TX200 S2 User Manual

7.8 Installing a Parallel Port

When a parallel port is necessary, install an optional parallel port.
For the parallel port location, refer to "1.3.2 Server (Rear View)" ( pg.25).

7.8.1 How to Install a Parallel Port

1
Turn off the server and connected devices, and unplug all power cables from
the outlet.
2
Remove the side cover.
"7.2 Removing and Attaching Covers" (pg.176)
3
Touch a metal part of the server to discharge static electricity.
4
Remove the ventilation system cover.
Release the latch on the ventilation system cover and lift it up to remove.
Ventilation
system cover
• When installing or removing a parallel port, turn off the server, all peripheral
devices, and any other connected devices. Also unplug all power cables from
the outlet.
Failure to do so can cause electric shock.
• Touch only the specified part of the printed circuit board.
Failure to do so could cause injury and also damage the server.
• Be careful to avoid injury when handling the parallel port connector panel
removed from the rear of the server.
Latch
PRIMERGY TX200 S2 User's Guide
7
225