Switchport Protected - D-Link DES-3010FA-TAA - Switch 10/100MBPS Mgmt Manual

D-Link DES-3010FA/GA CLI Reference Guide

switchport protected

The switchport protected Interface Configuration mode command overrides the FDB decision and sends all
Unicast, Multicast and Broadcast traffic to an uplink port. To return to the default configuration, use the no
form of the command .
Syntax
switchport protected {ethernet
no switchport protected
interface
— Specifies the uplink Ethernet port.
•
port-channel-number
•
Default Configuration
Overriding the FDB decision is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel)
User Guidelines
Packets to the MAC address of the device are sent to the device and not forwarded to the uplink.
•
Example
The following example overrides the FDB decision and sends all Unicast, Multicast and Broadcast traffic to
Ethernet port 7 from protected Ethernet port 8.
Console# config
Console(config)# interface ethernet 7
Console(config-if)# switchport protected ethernet 8
interface
| port-channel
— Specifies the port-channel uplink port.
Page 305
port-channel-number
}