AudioCodes Mediant 1000 User Manual page 210

ini File Field Name
Web Parameter Name
Auto Clock Trunk Priority
[AutoClockTrunkPriority]
Line Code
[LineCode]
Line Build Out Loss
[LineBuildOut.Loss]
Trace Level
[TraceLevel]
Framing Method
[FramingMethod]
SIP User's Manual
Table 5-43: E1/T1/J1 Configuration Parameters
Defines the trunk priority for auto-clock fallback (per trunk
parameter).
0 to 99 = priority (0 is the highest = default).
100 = the SW never performs a fallback to that trunk (usually
used to mark un-trusted source of clock).
Note: Fallback is enabled when the TDMBusPSTNAutoClockEnable
parameter is set to 1.
Use to select B8ZS or AMI for T1 spans, and HDB3 or AMI for E1
spans.
[0] B8ZS = use B8ZS line code (for T1 trunks only) default.
[1] AMI = use AMI line code.
[2] HDB3 = use HDB3 line code (for E1 trunks only).
Selects the line build out loss to be used for T1 trunks.
[0] 0 dB (default)
[1] -7.5 dB
[2] -15 dB
[3] -22.5 dB
Note: This parameter is not applicable for E1 trunks.
Defines the trace level:
[0] No Trace (default)
[1] Full ISDN Trace
[2] Layer 3 ISDN Trace
[3] Only ISDN Q.931 Messages Trace
[4] Layer 3 ISDN No Duplication Trace
Selects the physical framing method used for the trunk.
[0] = default according to protocol type E1 or T1. E1 default = E1
CRC4 MultiFrame Format extended G.706B (as c); T1 default =
T1 Extended SuperFrame with CRC6 (as D).
[1] = T1 SuperFrame Format (as B).
[a] = E1 DoubleFrame Format
[b] = E1 CRC4 MultiFrame Format
[c] = E1 CRC4 MultiFrame Format extended G.706B
[A] = T1 4-Frame multiframe.
[B] = T1 12-Frame multiframe (D4).
[C] = T1 Extended SuperFrame without CRC6
[D] = T1 Extended SuperFrame with CRC6
[E] = T1 72-Frame multiframe (SLC96)
[F] = J1 Extended SuperFrame with CRC6 (Japan)
210
Valid Range and Description
Mediant 1000
Document #: LTRT-83302