AudioCodes Mediant 1000 User Manual page 325

SIP User's Manual
ini File Field Name
Web Parameter Name
IsRegisterNeeded
RegistrarIP
RegistrarName
GWRegistrationName
AuthenticationMode
OOSOnRegistrationFail
RegistrationTime
RegistrationTimeDivider
RegistrationRetryTime
RegisterOnInviteFailure
RegistrationTimeThreshol
d
NumberOfActiveDialogs
PrackMode
AssertedIdMode
PAssertedUserName
UseAORInReferToHeader Defines the source for the SIP URI set in the Refer-to header of
UseTelURIForAssertedID
Version 5.2
Table 6-7: SIP Configuration Parameters
Valid Range and Description
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 84.
Defines the maximum number of active SIP dialogs that are not call
related (i.e., REGISTER and SUBSCRIBE). This parameter is used to
control the Registration / Subscription rate.
The valid range is 1 to 20. The default value is 20.
For a description of this parameter, refer to 'General Parameters' on
page 72.
For a description of this parameter, refer to 'General Parameters' on
page 72.
Defines a 'representative number' (up to 50 characters) that is used as
the User Part of the Request-URI in the P-Asserted-Id header of an
outgoing INVITE (for Tel-to-IP calls).
The default value is NULL.
outgoing REFER messages.
[0] = Use SIP URI from Contact header (default) of the initial call.
[1] = Use SIP URI from To/From header of the initial call.
For a description of this parameter, refer to 'General Parameters' on
page 72.
325
6. ini File Configuration
September 2007