Call Forward - AudioCodes Mediant 1000 User Manual

SIP User's Manual
2. In the' Caller ID/Name' field, enter the Caller ID string. The Caller ID string can contain
up to 18 characters. Note that when the FXS modules receives 'Private' or
'Anonymous' strings in the From header, it doesn't send the calling name or number to
the Caller ID display.
3. In the 'Presentation' field, select 'Allowed' [0] to send the string defined in the 'Caller
ID/Name' field when a Tel-to-IP call is made using this gateway port. Select
'Restricted' [1] if you don't want to send this string. (Refer to the note below.)
4. Repeat steps 2 and 3 for each gateway port.
5. Click the Submit button to save your changes.
6. To save the changes to flash memory, refer to 'Saving Configuration' on page 278.
Notes:
5.5.8.4

Call Forward

The gateway allows you to forward incoming IP Tel calls (using 302 response) based on
the gateway port to which the call is routed (applicable only to FXS modules).
The 'Call Forwarding Table' screen is applicable only if the Call Forward feature is enabled.
To enable Call Forward, set 'Enable Call Forward' to 'Enable' in the 'Supplementary
Services' screen, or EnableForward = 1 in the ini file (refer to 'SIP Configuration
Parameters' on page 323).
You can also configure the Call Forward table using the ini file parameter FwdInfo (refer to
'Analog Telephony Parameters' on page 350).
Version 5.2
•
When the 'Presentation' field is set to 'Restricted', the caller identity is
passed to the remote side using only the P-Asserted-Identity and P-
Preferred-Identity headers (AssertedIdMode).
•
The value of the 'Presentation' field can (optionally) be overridden by
configuring the 'Presentation' parameter in the 'Source Number
Manipulation' table.
•
157
5. Web-based Management
September 2007