Assigning An Ip Address Using The Cli; Accessing The Cli; Table 4-2: Configuration Parameters Available Via The Voice Menu - AudioCodes Mediant 1000 User Manual

SIP User's Manual
The following configuration parameters can be queried or modified via the voice menu:

Table 4-2: Configuration Parameters Available via the Voice Menu

Item Number at Menu
Prompt
1
2
3
4
7
11
12
99
4.3.4

Assigning an IP Address Using the CLI

Assigning an IP address using the command-line interface (CLI) is performed in two
stages:
1. Accessing the CLI (refer to 'Accessing the CLI' on page 53) using a standard Telnet
application or serial communication software (e.g., HyperTerminal
RS-232 port.
2. Assigning an IP address to the gateway (refer to 'Assigning an IP Address' on page
54).
4.3.4.1

Accessing the CLI

The procedure below describes how to access the CLI using either Telnet or RS-232
interface.
To access the CLI using the embedded Telnet server, take these 3
steps:
1. Enable the embedded Telnet server, by performing the following:
a. Access the gateway's Embedded Web Server (refer to 'Accessing the Embedded
Web Server' on page 60).
b. Open the 'Application Settings' screen (Advanced Configuration menu >
Network Settings > Application Settings option), and therein set the parameter
'Embedded Telnet Server' to 'Enable (Unsecured)' or 'Enable Secured (SSL)'.
For detailed information, refer to 'Configuring the Application Settings' on page
182.
Version 5.2
IP address
Subnet mask
Default Gateway IP address
Primary DNS server IP address
DHCP enable / disable
MGCP call agent IP address (N/A)
MGCP call agent port number (N/A)
Voice menu password (initially 12345).
Note: The voice menu password can also be changed using the parameter
VoiceMenuPassword (refer to 'Configuring the General Security Settings' on
page 232).
Description
53
4. Getting Started
) connected to the
TM
September 2007