AudioCodes Mediant 1000 User Manual page 77

SIP User's Manual
Parameter
Use "user=phone" in
From Header
[IsUserPhoneInFrom]
Use Tel URI for Asserted
Identity
[UseTelURIForAsserted
ID]
Tel to IP No Answer
Timeout
[IPAlertTimeout]
Enable Remote Party ID
[EnableRPIheader]
Add Number Plan and
Type to Remote Party ID
Header
[AddTON2RPI]
Version 5.2
Table 5-8: General Parameters (Protocol Definition)
[0] No = Doesn't use ';user=phone' string in From header (default).
[1] Yes = ';user=phone' string is part of the From header.
Determines the format of the URI in the P-Asserted and P-Preferred
headers.
[0] Disable = 'sip:' (default).
[1] Enable = 'tel:'.
Defines the time (in seconds) the gateway waits for a 200 OK response
from the called party (IP side) after sending an INVITE message. If the
timer expires, the call is released.
The valid range is 0 to 3600. The default value is 180.
Enable Remote-Party-ID (RPI) headers for calling and called numbers for
Tel IP calls.
Valid options include:
[0] Disable (default).
[1] Enable = RPI headers are generated in SIP INVITE messages for
both called and calling numbers.
[0] No = TON/PLAN parameters aren't included in the RPID header.
[1] Yes = TON/PLAN parameters are included in the RPID header
(default).
If RPID header is enabled (EnableRPIHeader = 1) and AddTON2RPI = 1,
it's possible to configure the calling and called number type and number
plan using the Number Manipulation tables for Tel IP calls.
Description
77
5. Web-based Management
September 2007