AudioCodes Mediant 1000 User Manual page 305

SIP User's Manual
ini File Field Name
Web Parameter Name
EnableDNSasOAM
EnableNTPasOAM
VLANSendNonTaggedOn
Native
Multiple IPs Parameters
EnableMultipleIPs
LocalMediaIPAddress
LocalMediaSubnetMask
LocalMediaDefaultGW
LocalControlIPAddress
LocalControlSubnetMask For a description of this parameter, refer to 'Configuring the IP Settings'
LocalControlDefaultGW
LocalOAMIPAddress
LocalOAMSubnetMask
LocalOAMDefaultGW
PPPoE Parameters
EnablePPPoE
PPPoEUserName
Version 5.2
Table 6-1: Networking Parameters
Valid Range and Description
This parameter applies to both Multiple IPs and VLAN mechanisms.
Multiple IPs: Determines the network type for DNS services.
VLAN: Determines the traffic type for DNS services.
[1] = OAM (default)
[0] = Control.
This parameter applies to both Multiple IPs and VLAN mechanisms.
Multiple IPs: Determines the network type for NTP services.
VLAN: Determines the traffic type for NTP services.
[1] = OAM (default)
[0] = Control.
Specify whether to send non-tagged packets on the native VLAN.
[0] = Sends priority tag packets (default).
[1] = Sends regular packets (with no VLAN tag).
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
For a description of this parameter, refer to 'Configuring the IP Settings'
on page 178.
Enables the PPPoE (Point-to-Point Protocol over Ethernet) feature.
[0] = Disable (default)
[1] = Enable
User Name for PAP or Host Name for CHAP authentication.
The valid range is a string of up to 47 characters. The default value is 0.
305
6. ini File Configuration
September 2007