Below is an example of an ini file containing VLAN and Multiple IPs parameters:
; VLAN Configuration
VlanMode=1
VlanOamVlanId=4
VlanNativeVlanId=4
VlanControlVlanId=5
VlanMediaVlanID=6
; Multiple IPs Configuration
EnableMultipleIPs=1
LocalMediaIPAddress=10.33.174.50
LocalMediaSubnetMask=255.255.0.0
LocalMediaDefaultGW=10.33.0.1
LocalControlIPAddress=10.32.174.50
LocalControlSubnetMask=255.255.0.0
LocalControlDefaultGW=0.0.0.0
LocalOAMPAddress=10.31.174.50
LocalOAMSubnetMask=255.255.0.0
LocalOAMDefaultGW=0.0.0.0
; IP Routing table parameters
RoutingTableDestinationsColumn = 130.33.4.6, 83.4.87.6
RoutingTableDestinationMasksColumn = 255.255.255.255 ,
255.255.255.0
RoutingTableGatewaysColumn = 10.32.0.1 , 10.31.0.1
RoutingTableInterfacesColumn = 1 , 0
RoutingTableHopsCountColumn = 20,20
2.
Use the BootP/TFTP utility (refer to the SIP Series Reference Manual) to load and
burn (-fb option) the firmware version and the ini file you prepared in the previous step
to the gateway (VLANs and multiple IPs support is available only when the firmware is
burned to flash).
3.
Reset the gateway after disabling it on the BootP/TFTP utility.
SIP User's Manual
438
Mediant 1000
Document #: LTRT-83302