Configuring The Digital Gateway Parameters - AudioCodes Mediant 1000 User Manual

SIP User's Manual
5.5.9

Configuring the Digital Gateway Parameters

The 'Digital Gateway' screen is used to configure miscellaneous digital parameters.
To configure the digital gateway parameters, take these 4 steps:
1. Open the 'Digital gateway Parameters' screen (Protocol Management menu >
Digital Gateway Parameters).
2. Configure the Digital Gateway parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to 'Saving Configuration' on page 278.
Version 5.2
Figure 5-32: Digital Gateway Parameters Screen
161
5. Web-based Management
September 2007