AudioCodes Mediant 1000 User Manual page 115

SIP User's Manual
Parameter
Enable Call Forward
[EnableForward]
Enable Call Waiting
[EnableCallWaiting]
Number of Call Waiting
Indications
[NumberOfWaitingIndic
ations]
Time Between Call
Waiting Indications
[TimeBetweenWaitingIn
dications]
Time Before Waiting
Indication
[TimeBeforeWaitingIndi
cation]
Waiting Beep Duration
[WaitingBeepDuration]
Version 5.2
Table 5-13: Supplementary Services Parameters
[0] Disable = Disable the Call Forward service.
[1] Enable = Enable Call Forward service (using REFER) (default).
For FXS modules, a Call Forward table must be defined to use the Call
Forward service. To define the Call Forward table, refer to Call Forward on
page 157.
Note: To use this service, the gateways at both ends must support this
option.
[0] Disable = Disable the Call Waiting service.
[1] Enable = Enable the Call Waiting service (default).
If enabled, when an FXS module receives a call on a busy endpoint, it
responds with a 182 response (and not with a 486 busy). The gateway
plays a call waiting indication signal. When hook-flash is detected, the
gateway switches to the waiting call.
The gateway that initiated the waiting call plays a Call Waiting Ringback
tone to the calling party after a 182 response is received.
Notes:
The gateway's Call Progress Tones file must include a Call Waiting
Ringback tone (caller side) and a Call Waiting tone (called side, FXS
only).
The EnableHold parameter must be enabled on both the calling and the
called side.
You can use the ini file parameter table CallWaitingPerPort to enable
Call Waiting per port (refer to Call Waiting on page 160).
For information on the Call Waiting feature, refer to 'Call Waiting' on
page 418.
For information on the Call Progress Tones file, refer to the SIP Series
Reference Manual.
Number of waiting indications that are played to the receiving side of the
call (FXS only) for Call Waiting.
The default value is 2.
Difference (in seconds) between call waiting indications (FXS only) for call
waiting.
The default value is 10 seconds.
Defines the interval (in seconds) before a call waiting indication is played
to the port that is currently in a call (FXS only).
The valid range is 0 to 100. The default time is 0 seconds.
Duration (in msec) of waiting indications that are played to the receiving
side of the call (FXS only) for Call Waiting.
The default value is 300.
Description
115
5. Web-based Management
September 2007