Table 5-9: Proxy & Registration Parameters - AudioCodes Mediant 1000 User Manual

SIP User's Manual
2. Configure the Proxy and Registration parameters according to the following table.
3. Click the Submit button to save your changes, or click the Register or Un-Register
buttons to save your changes and register / unregister to a Proxy / Registrar.
4. To save the changes to flash memory, refer to 'Saving Configuration' on page 278.
Parameter
Enable Proxy
[IsProxyUsed]
Proxy parameters (these parameter fields only appear if 'Enable Proxy' is enable)
Proxy Name
[ProxyName]
Proxy IP Address
[ProxyIP]
Version 5.2
Table 5-9: Proxy & Registration Parameters
Enables the use of a Proxy server.
[0] Don't Use Proxy = Proxy isn't used, the internal routing table is used
instead (default).
[1] Use Proxy = Proxy is used.
If you are using a Proxy server, enter the IP address of the primary Proxy
server in the 'Proxy IP address' field. If you are not using a Proxy server, you
must configure the Tel to IP Routing table on the gateway (described in 'Tel
to IP Routing Table' on page 134).
Defines the Home Proxy Domain Name. If specified, the Proxy Name is
used as Request-URI in REGISTER, INVITE and other SIP messages. If not
specified, the Proxy IP address is used instead.
IP address (and optionally port number) of the primary Proxy server you are
using.
Enter the IP address as FQDN or in dotted decimal notation (e.g.,
201.10.8.1). You can also specify the selected port in the format: <IP
Address>:<port>.
If you enable Proxy Redundancy (by setting EnableProxyKeepAlive = 1 or
2), the gateway can work with up to 15 Proxy servers. If there is no response
from the primary Proxy, the gateway tries to communicate with the
redundant Proxies. When a redundant Proxy is found, the gateway either
continues working with it until the next failure occurs or reverts to the primary
Proxy (refer to the 'Redundancy Mode' parameter). If none of the Proxy
servers respond, the gateway goes over the list again.
The gateway also provides real time switching (hotswap mode), between the
primary and redundant proxies (IsProxyHotSwap = 1). If the first Proxy
doesn't respond to INVITE message, the same INVITE message is
immediately sent to the next Proxy. The same logic applies to REGISTER
messages (in case that RegistrarIP is not defined).
Notes:
This parameter is applicable only if you select 'Use Proxy' in the 'Enable
Proxy' field.
If EnableProxyKeepAlive = 1 or 2, the gateway monitors the connection
with the Proxies by using keep-alive messages (OPTIONS or
REGISTER).
To use Proxy Redundancy, you must specify one or more redundant
Proxies using multiple 'ProxyIP= <IP address>' definitions.
When port number is specified (e.g., domain.com:5080), DNS
NAPTR/SRV queries aren't performed, even if ProxyDNSQueryType is
set to 1 or 2.
Description
85
5. Web-based Management
September 2007