Table 5-31: Ipmedia Configuration Parameters - AudioCodes Mediant 1000 User Manual

ini File Field Name
Web Parameter Name
Number of Media
Channels
[MediaChannels]
Enable Voice Streaming
[EnableVoiceStreaming]
NetAnn Announcement ID
[NetAnnAnncID]
MSCML ID
[MSCMLID]
Transcoding ID
[TranscodingID]
Conference
Conference ID
[ConferenceID]
Beep upon New
Participant in Conference
[BipOnConference]
SIP User's Manual

Table 5-31: IPmedia Configuration Parameters

Valid Range and Description
The number of DSP channels that are allocated for IP conferences, IP
streaming and IP Transcoding (other DSP channels can be used for
PSTN Gateway).
The maximum value of Media Channels depends on the number of
installed Media Processing modules (MPM): 1 module = 20 channels; 2
modules = 60; 3 modules = 100. The default value is 0.
Enables/disables the HTTP Voice Streaming application (play / record).
[0] Disable = Voice Streaming is disabled (default).
[1] Enable = Voice Streaming is enabled.
NetAnn identification string (up to 16 characters), used to play an
announcement using the NetAnn interface. The application server sends
a regular SIP INVITE message with SIP URI that includes this identifier
string and a "play=" parameter that identifies the necessary
announcement.
The default value is 'annc'.
Example 1: INVITE sip: annc@10.2.3.4;play=http://localhost/1.
Example 2: INVITE sip:
annc@10.2.3.4;play=http://10.2.3.4/Annc/hello.wav.
MSCML identification string (up to 16 characters). To start an MSCML
session the application server sends a regular SIP INVITE message with
a SIP URI that includes this string.
The default value is 'ivr'.
For example: INVITE sip:ivr@10.2.3.4
Subsequent INFO message(s) carry the requests and responses.
Transcoding identification string (up to 16 characters), used for identifying
an incoming Transcoding call.
The default value is 'trans'.
For detailed information on Transcoding, refer to 'NetAnn Interface' on
page 463.
Conference Identification string (up to 16 characters).
The default value is 'conf'.
For example: ConferenceID = MyConference
Note: To join a conference, the INVITE URI must include the Conference
ID string, preceded by the number of the participants in the conference,
and terminated by a unique number.
For example: Invite sip:4MyConference1234@10.1.10.10.
INVITE messages with the same URI join the same conference.
Configure this parameter for a beep to be played when a new participant
joins a conference and when a participant leaves a conference (in the
latter case, a beep of a different pitch is heard).
[0] Disable = Beep is disabled.
[1] Enable = Beep is enabled (default).
176
Mediant 1000
Document #: LTRT-83302