AudioCodes Mediant 1000 User Manual page 376

ini File Field Name
Web Parameter Name
RTPSIDCoeffNum
DTMFVolume
DTMFGenerationTwist
DTMFInterDigitInterval
DTMFDigitLength
RxDTMFHangOverTime
TxDTMFHangOverTime
DTMFTransportType
AnswerDetectorSensitivity
RFC2833PayloadType
UDTDetectorFrequencyDeviati
on
CPTDetectorFrequencyDeviati
on
MGCPDTMFDetectionPoint
MinFlashHookTime
FlashHookOption
FlashHookPeriod
SIP User's Manual
Table 6-14: Channel Parameters
Valid Range and Description
Determines the number of spectral coefficients added to an SID
packet being sent according to RFC 3389. Valid only if
EnableStandardSIDPayloadType is set to 1.
The valid values are [0] (default), [4], [6], [8] and [10].
For a description of this parameter, refer to 'Configuring the Voice
Settings' on page 191.
For a description of this parameter, refer to 'Configuring the Voice
Settings' on page 191.
Time in msec between generated DTMF digits to PSTN side (if
TxDTMFOption = 1, 2 or 3).
The default value is 100 msec. The valid range is 0 to 32767.
Time in msec for generating DTMF tones to the PSTN side (if
TxDTMFOption = 1, 2 or 3).
The default value is 100 msec. The valid range is 0 to 32767.
Defines the Voice Silence time (in msec units) after playing DTMF
or MF digits to the Tel / PSTN side that arrive as Relay from the IP
side.
Valid range is 0 to 2,000 msec. The default is 1,000 msec.
Defines the Voice Silence time (in msec units) after detecting the
end of DTMF or MF digits at the Tel / PSTN side when the DTMF
Transport Type is either Relay or Mute.
Valid range is 0 to 2,000 msec. The default is 100 msec.
For a description of this parameter, refer to 'Configuring the Voice
Settings' on page 191.
For a description of this parameter, refer to Configuring the Voice
Settings on page 191.
For a description of this parameter, refer to 'DTMF & Dialing
Parameters' on page 98.
Defines the deviation (in Hz) allowed for the detection of each
signal frequency. Units are in Hertz.
The valid range is 1 to 50. The default value is 50 Hz.
Defines the deviation (in Hz) allowed for the detection of each CPT
signal frequency.
The valid range is 1 to 30. The default value is 10 Hz.
[0] = DTMF event is reported on the end of a detected DTMF
digit.
[1] = DTMF event is reported on the start of a detected DTMF
digit (default).
For a description of this parameter, refer to 'Configuring the Hook-
Flash Settings' on page 204.
For a description of this parameter, refer to 'DTMF & Dialing
Parameters' on page 98.
For a description of this parameter, refer to 'Configuring the Hook-
Flash Settings' on page 204.
376
Mediant 1000
Document #: LTRT-83302