Assigning An Ip Address - AudioCodes Mediant 1000 User Manual

c. Save these settings to the flash memory and reset the gateway by performing the
following:
a.
b.
2. Use a standard Telnet application to connect to the gateway's embedded Telnet
server. Note that if the Telnet server is set to SSL mode, a special Telnet client is
required on your PC to connect to the Telnet interface over a secured connection.
3. Login using the default username ('Admin') and password ('Admin').
The procedure below describes how to establish a serial communications link with the
gateway (using serial communication software such as HyperTerminal
232 interface.
To access the CLI using the RS-232 port , take these 2 steps:
1. Connect the gateway's RS-232 port to your PC (refer to Connecting the Mediant 1000
RS-232 Port to a PC on page
2. Use a serial communication software (e.g., HyperTerminal
communications port settings:
•
Baud Rate: 115,200 bps
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
The CLI prompt appears.
4.3.4.2

Assigning an IP Address

Once you have accessed the CLI, follow the procedure below for assigning a new IP
address.
To assign an IP address via the CLI, take these 4 steps:
1. At the prompt, type conf, and then press <Enter>; the configuration folder is
accessed.
2. To view the current network parameters, at the prompt, type GCP IP, and then press
<Enter>; the current network settings are displayed.
3. Change the network settings by typing the following:
SCP IP [ip_address] [subnet_mask] [default_gateway]
For example,
SCP IP 10.13.77.7 255.255.0.0 10.13.0.1
The new settings take effect on-the-fly. Connectivity is active at the new IP address.
Note: This command requires you to enter all three network parameters (each
separated by a space).
4. To save the configuration, at the prompt, type SAR, and then press <Enter>; the
gateway restarts with the new network settings.
SIP User's Manual
Click the Maintenance button on the main menu bar; the 'Maintenance
Actions' screen is displayed.
From the 'Burn to FLASH' drop-down list, select 'Yes', and then click the
Reset button; the gateway shuts down and restarts.
42 .
54
Mediant 1000
) through the RS-
TM
) with the following
TM
Document #: LTRT-83302