AudioCodes Mediant 1000 User Manual page 101

SIP User's Manual
Parameter
Hook-Flash Option
[HookFlashOption]
Use INFO for Hook-Flash
[IsHookFlashUsed]
Digit Mapping Rules
[DigitMapping]
Dial Tone Duration [sec]
[TimeForDialTone]
Version 5.2
Table 5-11: DTMF and Dialing Parameters
Supported hook-flash Transport Type (method by which hook-flash is sent
and received).
Valid options include:
[0] Not Supported = Hook-Flash indication isn't sent (default)
[1] INFO = Send proprietary INFO message with Hook-Flash indication
[4] RFC 2833
Notes:
FXO modules support the receiving of RFC 2833 Hook-Flash signals.
The FXS modules send HookFlash signals only if EnableHold = 0.
This parameter is obsolete; use instead the parameter HookFlashOption.
Digit map pattern (used to reduce the dialing period when Overlap dialing
is used). If the digit string (dialed number) has matched one of the patterns
in the digit map, the gateway stops collecting digits and starts to establish
a call with the collected number.
The digit map pattern contains up to 52 options separated by a vertical bar
(|).
The maximum length of the entire digit pattern is limited to 152 characters.
Available notations:
[n-m] represents a range of numbers (not letters)
'.' (single dot) represents repetition
'x' represents any single digit
'T' represents a dial timer (configured by TimeBetweenDigits
parameter)
'S' should be used when a specific rule, that is part of a general rule, is
to be applied immediately. For example, if you enter the general rule
x.T and the specific rule 11x, you should append 'S' to the specific rule
11xS.
For example:
11xS|00T|[1-7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T
Note: The digitmap mechanism is applicable only when ISDN Overlap
dialing is used (ISDNRxOverlap = 1).
Duration (in seconds) that the dial tone is played (for digital interface: to an
ISDN terminal).
For digital interfaces: This parameter is applicable to overlap dialing when
ISDNInCallsBehavior = 65536. The dial tone is played if the ISDN Setup
message doesn't include the called number. The valid range is 0 to 60.
The default time is 5 seconds.
For analog interfaces: FXS module ports play the dial tone after the phone
is picked up (off hook); while FXO module ports play the dial tone after port
is seized in response to ringing. The default time is 16 seconds.
Notes:
During play of dial tone, the gateway waits for DTMF digits.
TimeForDialTone is not applicable when Automatic Dialing is enabled.
Description
101
5. Web-based Management
September 2007