AudioCodes Mediant 1000 User Manual page 310

ini File Field Name
Web Parameter Name
CDRSyslogServerIP
HeartBeatDestIP
HeartBeatDestPort
HeartBeatIntervalmsec
EnableRAI
RAIHighThreshold
RAILowThreshold
RAILoopTime
Disconnect Supervision Parameters
DisconnectOnBrokenCon
nection
BrokenConnectionEvent
Timeout
EnableSilenceDisconnect For a description of this parameter, refer to 'General Parameters' on
FarEndDisconnectSilenc
ePeriod
SIP User's Manual
Table 6-2: System Parameters
Valid Range and Description
For a description of this parameter, refer to 'General Parameters' on
page 103.
Destination IP address (in dotted format notation) to which the gateway
sends proprietary UDP 'ping' packets.
The default IP address is 0.0.0.0.
Destination UDP port to which the heartbeat packets are sent.
The range is 0 to 64000. The default is 0.
Delay (in msec) between consecutive heartbeat packets.
[10] = 100000.
[-1] = disabled (default).
[0] = Disable RAI (Resource Available Indication) service (default).
[1] = Enable RAI service.
If RAI is enabled, an SNMP 'acBoardCallResourcesAlarm' Alarm Trap is
sent if gateway's busy endpoints exceed a predefined (configurable)
threshold.
High Threshold (in percentage) that defines the gateway's busy
endpoints.
The range is 0 to 100. The default value is 90%.
When the percentage of the gateway's busy endpoints exceeds the
value configured in High Threshold, the gateway sends an SNMP
'acBoardCallResourcesAlarm' Alarm Trap with a 'major' Alarm Status.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of "enabled" endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group table).
Low Threshold (in percentage) that defines the gateway's busy
endpoints.
The range is 0 to 100. The default value is 90%.
When the percentage of the gateway's busy endpoints falls below the
value defined in Low Threshold, the gateway sends an SNMP
'acBoardCallResourcesAlarm' Alarm Trap with a 'cleared' Alarm Status.
Time interval (in seconds) that the gateway checks for resource
availability.
The default is 10 seconds.
For a description of this parameter, refer to 'General Parameters' on
page 103.
For a description of this parameter, refer to 'General Parameters' on
page 103.
page 103.
For a description of this parameter, refer to 'General Parameters' on
page 103.
310
Mediant 1000
Document #: LTRT-83302