Getting Started; Configuration Concepts; Table 4-1: Default Networking Parameters - AudioCodes Mediant 1000 User Manual

SIP User's Manual
4

Getting Started

The gateway is supplied with default networking parameters (i.e., MAC and IP addresses,
as listed in the table below) and with an application software (cmp file) residing on its flash
memory (with factory default parameters).
Before you begin configuring the gateway, refer to 'Configuration Concepts' on page
a description of the available gateway configuration methods. Using a preferred method,
change the gateway's default IP address to correspond with your network environment
(refer to 'Assigning an IP Address' on page 50).
For information on quickly setting up the gateway with basic parameters using a standard
Web browser, refer to 'Configuring the Basic Parameters' on page 55.
Parameter
IP Address
Subnet Mask
Default Gateway IP Address
4.1

Configuration Concepts

You can deploy the gateway in a wide variety of applications enabled by its parameters
and configuration files (e.g., Call Progress Tones). The parameters can be configured and
configuration files can be loaded using the following tools:
A standard Web browser (described in 'Web-based Management' on page 57).
A configuration file referred to as the ini file. For information on how to use the ini file,
refer to 'ini File Configuration' on page 293.
An SNMP browser software (refer to the SIP Series Reference Manual).
AudioCodes' Element Management System (refer to AudioCodes' EMS User's Manual
or EMS Product Description).
To upgrade the gateway (i.e., load new software or configuration files), use the gateway's
Embedded Web Server's Software Upgrade Wizard (refer to 'Software Upgrade Wizard' on
page 262), or alternatively, use the BootP/TFTP configuration utility (refer to the SIP Series
Reference Manual).
Version 5.2

Table 4-1: Default Networking Parameters

10.1.10.10
255.255.0.0
0.0.0.0
47
4. Getting Started
Default Value
September 2007
47 for