Main Menu Bar; Saving Changes; Entering Phone Numbers In Various Tables - AudioCodes Mediant 1000 User Manual

5.4.1

Main Menu Bar

The main menu bar of the Embedded Web Server provides the following menus:
Quick Setup: Accesses the 'Quick Setup' screen for quickly configuring the gateway's
basic settings.For a full list of configurable parameters, directly access the Protocol
Management and Advanced Configuration menus. An example of the Quick Setup
configuration is described in 'Configuring the Basic Parameters' on page 55.
Protocol Management: used to configure the gateway's control protocol parameters
and tables (refer to 'Protocol Management' on page 71).
Advanced Configuration: used to configure the gateway's advanced configuration
parameters.
Status & Diagnostics: use to view Syslog messages, hardware / software product
information, and to assess the gateway's statistics and IP connectivity information
(refer to 'Status & Diagnostics' on page 251).
Software Update: used to load new software or configuration files to the gateway
(refer to 'Software Update' on page 262).
Maintenance: used to remotely lock/unlock the gateway (refer to 'Locking and
Unlocking the Gateway' on page 276), save configuration changes to the non-volatile
flash memory (refer to 'Saving Configuration' on page 278), and reset the gateway
(refer to 'Resetting the Gateway' on page 279).
5.4.2

Saving Changes

To apply changes to the gateway's volatile memory (RAM), click the Submit button that
appears in the screen in which you are working. Modifications to parameters with on-the-fly
capabilities are immediately applied to the gateway; other parameters are updated only
after a gateway reset.
Parameters saved to the volatile memory (i.e., not burned to flash memory), revert to their
previous settings after a hardware reset (or if the gateway is powered down). However,
when performing a software reset (i.e., using the Embedded Web Server or SNMP), you
can also choose to save the parameter settings to the non-volatile memory (i.e., flash). To
save the changes to flash, refer to 'Saving Configuration' on page 278.
Note:
5.4.3

Entering Phone Numbers in Various Tables

Phone numbers or prefixes entered into various tables on the gateway such as the Tel to
IP routing table, must be entered without any formatting characters. For example, if you
wish to enter the phone number 555-1212, it must be entered as 5551212 without the
hyphen (-). If the hyphen is entered, the entry is not valid. The hyphen character is used in
number entry only, as part of a range definition. For example, the entry [20-29] means 'all
numbers in the range 20 to 29.
SIP User's Manual
Parameters preceded by an exclamation mark (!) are not changeable on-the-
fly and require that the device be reset.
62
Mediant 1000
Document #: LTRT-83302