AudioCodes Mediant 1000 User Manual page 56

4. When working with a Proxy server, set the 'Working with Proxy' field to 'Yes', and then
enter the IP address of the primary Proxy server in the field 'Proxy IP address'. When
no Proxy is used, the internal routing table is used to route the calls.
5. Enter the Proxy name in the field 'Proxy Name'. If Proxy name is used, it replaces the
Proxy IP address in all SIP messages. This means that messages are still sent to the
physical Proxy IP address, but the SIP URI contains the Proxy name instead.
6. Configure 'Enable Registration' to either one of the following:
•
'Disable' = the gateway doesn't register to a Proxy server/Registrar (default).
•
'Enable' = the gateway registers to a Proxy server/Registrar at power up and
every 'Registration Time' seconds. For detailed information on the parameter
'Registration Time', refer to 'Proxy & Registration Parameters' on page 84.
7. To configure the Coders Table, click the arrow button next to 'Coders Table'. For
information on how to configure the Coders Table, refer to 'Coders' on page 94.
8. To configure the Tel to IP Routing Table, click the arrow button next to 'Tel to IP
Routing Table'. For information on how to configure the Tel to IP Routing Table, refer
to 'Tel to IP Routing Table' on page 134.
9. To configure the E1/T1 B-channels, click the arrow button next to 'Trunk Group Table'.
For information on how to configure the Trunk Group Table, refer to Configuring the
Trunk Group Table on page 150.
10. Click the Reset button, and then at the prompt, click OK; the gateway applies the
changes and restarts.
11. After the gateway has reset, access the 'Trunk Settings' screen (Advanced
Configuration > Trunk Settings), and select the gateway's E1/T1 protocol type and
Framing method that best suits your system requirements. For information on how to
configure the Trunk Settings, refer to 'Trunk Settings' on page 206.
You are now ready to start configuring the gateway. To prevent unauthorized access to the
gateway, it's recommended that you change the default username and password used to
access the Embedded Web Server. Refer to 'Configuring the Web User Accounts' on page
223 on how to change the username and password.
Tip:
SIP User's Manual
Once the gateway is configured correctly, back up your settings by saving a
copy of the VoIP gateway configuration (ini file) to a directory on your PC.
This saved file can be used to restore configuration settings at a later date.
For information on backing up and restoring the gateway's configuration, refer
to 'Restoring and Backing up Configuration' on page 280.
56
Mediant 1000
Document #: LTRT-83302