AudioCodes Mediant 1000 User Manual page 341

SIP User's Manual
ini File Field Name
Web Parameter Name
CASTableIndex_x
CASFileName_0
CASFileName_1
CASFileName_7
CASTablesNum
IdleABCDPattern
IdlePCMPattern
LineBuildOut.Loss
ISDNRxOverlap_x
ISDNRxOverlap
R2Category
HeldTimeout
CallPriorityMode
MLPPDefaultNamespace For a description of this parameter, refer to 'Configuring the Digital
SIPDefaultCallPriority
MLPPDiffserv
Version 5.2
Table 6-10: PSTN Parameters
Valid Range and Description
For a description of this parameter, refer to 'Trunk Settings' on page 206.
CAS file name (e.g., 'E_M_WinkTable.dat') that defines the CAS
protocol. It is possible to define up to eight different CAS files by
repeating this parameter. Each CAS file can be associated with one or
more of the gateway trunks using the parameter CASTableIndex_x.
1 to 8. Indicates how many CAS protocol configurations files are loaded.
For a description of this parameter, refer to 'Configuring the TDM Bus
Settings' on page 221.
For a description of this parameter, refer to 'Configuring the TDM Bus
Settings' on page 221.
For a description of this parameter, refer to 'Trunk Settings' on page 206.
For a description of this parameter, refer to 'Trunk Settings' on page 206.
[0] = Disabled (default).
[1] = Enabled.
Any number bigger than one = Number of digits to receive.
Notes:
If enabled, the gateway receives ISDN called number that is sent in
the 'Overlap' mode.
The INVITE to IP is sent only after the number (including 'Sending
Complete' Info Element) was fully received (in SETUP and/or
subsequent INFO Q.931 messages).
For detailed information on ISDN overlap dialing, refer to ISDN Overlap
Dialing on page 444.
For a description of this parameter, refer to 'Configuring the Digital
Gateway Parameters' on page
Determines the time period the gateway can stay on-hold. If a Resume
(un-hold Re- INVITE) message is received before the timer expires, the
call is renewed. If this timer expires, the call is released.
[-1] = Indefinitely (default).
[0 - 2400] =Time to wait in seconds.
Currently applicable only to MFC R2 CAS variants.
For a description of this parameter, refer to 'Configuring the Digital
Gateway Parameters' on page 161.
Gateway Parameters' on page 161.
For a description of this parameter, refer to 'Configuring the Digital
Gateway Parameters' on page 161.
For a description of this parameter, refer to 'Configuring the Digital
Gateway Parameters' on page 161.
341
6. ini File Configuration
161
September 2007